纺织品纤维质量含量（棉）检测数据

随着社会的高速发展，人们对于生活质量方面要求不断的提高，对于工业产品的质量要求也在提高。在工业产品生产中，纺织品是人们生产生活的必需品，所以必须加强纺织品纤维含量检测，提高数据精度，保护人们的生命安全，促进社会稳定的发展。1.数据采集，采用显微放大后别各类纤维测维直径或截面面，结合测得的各类纤维根数,按需分别计算纤维质量含量；2.数据计算，对横截面形纤维,根据FZ/T 01101-2008 纺织品 纤维含量的测定 物理法计算纤维质量含量,计算结果按GB/T 8170 修约至0.1，计算公式：P=（N*d²*ρ）/Σ（N*d²*ρ）*100；3.数据说明：P—纤维的质量含量，%；N—纤维的计数测量根数；d²—纤维的直平方的平均值，单位为平方微米(um²)；ρ=纤维的密度(棉的密度值为1.54)单位为克每立方米(g/cm³)。4.数据应用：将检测的数据与标准值比对，若纤维质量含量≥合格标准值，则该产品纤维质量含量合格，反之则不合格。

With the rapid advancement of society, people's demands for quality of life are continuously increasing, and so are the quality requirements for industrial products.
In industrial production, textiles are essential necessities for both production and daily life. Therefore, it is imperative to strengthen the detection of fiber content in textiles, improve the accuracy of test data, safeguard people's lives and safety, and promote the stable development of society.
1. Data Collection: Identify various types of fibers through microscopic magnification, measure their diameters or cross-sectional areas, combine with the counted quantity of each fiber type, and calculate the mass content of fibers individually as required.
2. Data Calculation: For cross-sectional fibers, calculate the mass content of fibers in accordance with FZ/T 01101-2008: Determination of Fiber Content in Textiles – Physical Method, and round the calculated results to 0.1 in accordance with GB/T 8170. The calculation formula is: P = (N*d²*ρ)/Σ(N*d²*ρ) * 100.
3. Data Explanation: P — mass content of fibers, in %; N — counted and measured number of fibers; d² — average value of the squared fiber diameter, unit: square micrometers (μm²); ρ — density of fibers (the density of cotton is 1.54), unit: grams per cubic centimeter (g/cm³).
4. Data Application: Compare the detected test data with standard values. If the fiber mass content is greater than or equal to the qualified standard value, the fiber mass content of the product is deemed qualified; otherwise, it is unqualified.

搜集汇总

数据集介绍

特点

该数据集包含260条纺织品纤维质量含量（棉）检测数据，涵盖样品名称、检测项目、纤维质量含量等10个字段，每年更新一次，主要用于纺织品纤维含量检测和质量判定。