普通胶合板胶合强度检测数据

根据国家要求，普通胶合板胶合强度是产品是否达标的一项重要且强制性标准，胶合强度越大，才能保证产品的质量，本数据对普通胶合板胶合强度作出检测，为企业生产做出参考，为地板产品优良品质做出依据。1、产品检测：对全桦胶合板进行抽样检测，温度保持在22℃，相对湿度52%随机抽取样本长度25mm左右测量并记录，测量样本宽度并记录，样本做破坏试验，记录样本破坏最大荷载并记录；2、数据处理：胶合强度=破坏最大荷载/（样本长度*样本宽度）；3、根据GB/T 9846-2015  普通胶合板标准，若样本中胶合强度大于等于1.00Mpa则认为该样本合格，否则为不合格；4、对普通胶合板胶合强度的检验检测，为企业生产标准化生产做出有效参考。

According to national regulatory requirements, the bonding strength of ordinary plywood is an important and mandatory indicator for determining whether a product meets standards. Higher bonding strength ensures better product quality. This dataset conducts bonding strength detection for ordinary plywood, providing references for enterprise production and a basis for guaranteeing the excellent quality of flooring products. 1. Product Testing: Sampling tests are performed on all-birch plywood. The tests are carried out at a temperature of 22°C and a relative humidity of 52%. Randomly select samples with a length of approximately 25 mm, measure and record the length and width of each sample, perform a destructive test on the samples, and record the maximum failure load of each sample. 2. Data Processing: Bonding strength is calculated as: Bonding strength = Maximum failure load / (Sample length × Sample width). 3. According to the GB/T 9846-2015 Standard for Ordinary Plywood, a sample is deemed qualified if its bonding strength is greater than or equal to 1.00 MPa; otherwise, it is considered unqualified. 4. The inspection and testing of ordinary plywood’s bonding strength provides effective references for the standardized production of enterprises.

搜集汇总

数据集介绍

特点

该数据集记录了普通胶合板的胶合强度检测数据，用于评估产品是否符合国家标准，支持企业标准化生产和质量控制。